Convert mmol/L and mg/dL by marker
Pick the marker first, then the direction. Each marker has its own factor, set by the weight of its molecule, so a glucose factor applied to cholesterol or triglycerides gives a wrong answer.
Educational tool, not a diagnosis. Factors are derived from molar mass and shown to four significant figures; labs sometimes round them (18 for glucose, 0.25 for calcium, 60 for uric acid), so your report may differ in the last digit. Converting a value does not convert its reference range: always read a result against the range your own laboratory printed. Some markers, such as Lp(a), have no exact mass-to-molar conversion.
How to convert mmol/L to mg/dL
A result in millimoles per litre counts molecules. A result in milligrams per deciliter weighs them. To move from one to the other you need the weight of one mole of the molecule, its molar mass:
mg/dL = mmol/L × (molar mass ÷ 10)
The division by 10 converts litres to deciliters. Glucose has a molar mass of 180.16 grams per mole, so its factor is 18.02: a fasting glucose of 5.6 mmol/L is about 101 mg/dL. Going the other way, you divide by the same factor. For markers reported in micromoles per litre, such as creatinine, the factor is 1,000 times larger, which is why creatinine uses 88.4 rather than 0.0884. The creatinine unit converter applies it in both directions, with a conversion chart and the adult ranges for women and men.
Why there is no universal conversion factor
The most common conversion mistake is to treat 18 as the mmol/L to mg/dL factor for everything. It is the factor for glucose only. Cholesterol is a heavier molecule, at 386.65 grams per mole, so a cholesterol result of 5.2 mmol/L is 201 mg/dL, not 94. A triglyceride, built from three fatty acids on a glycerol backbone, is heavier again, which gives a factor of 88.57. The same printed number, 2.0 mmol/L, is 36 mg/dL of glucose, 77 mg/dL of cholesterol and 177 mg/dL of triglycerides.
Urea is a special case. US laboratories report blood urea nitrogen, the weight of only the two nitrogen atoms in each urea molecule, while most other countries report urea itself in mmol/L. Urea in mmol/L multiplied by 2.801 gives BUN in mg/dL.
Quick-reference conversion factors
| Marker | SI unit | SI to mg/dL | mg/dL to SI | Molar mass |
|---|---|---|---|---|
| Glucose | mmol/L | × 18.02 | × 0.05551 | 180.16 g/mol |
| Total, LDL, HDL and non-HDL cholesterol | mmol/L | × 38.67 | × 0.02586 | 386.65 g/mol |
| Triglycerides | mmol/L | × 88.57 | × 0.01129 | about 886 g/mol (as triolein) |
| Urea (mmol/L) to BUN (mg/dL) | mmol/L | × 2.801 | × 0.3570 | 28.01 g/mol of urea nitrogen |
| Calcium | mmol/L | × 4.008 | × 0.2495 | 40.078 g/mol |
| Uric acid | µmol/L | ÷ 59.48 | × 59.48 | 168.11 g/mol |
| Creatinine | µmol/L | ÷ 88.40 | × 88.40 | 113.12 g/mol |
| Bilirubin | µmol/L | ÷ 17.10 | × 17.10 | 584.66 g/mol |
Triglycerides are a mixture of molecules rather than one compound, so their factor is a convention based on triolein, a typical triglyceride. That makes it slightly less exact than the glucose or cholesterol factor, though the difference is far smaller than normal day-to-day variation.
Worked examples
| Result | Calculation | US units |
|---|---|---|
| Glucose 5.6 mmol/L | 5.6 × 18.02 | 101 mg/dL |
| Glucose 7.0 mmol/L | 7.0 × 18.02 | 126 mg/dL |
| Total cholesterol 5.2 mmol/L | 5.2 × 38.67 | 201 mg/dL |
| Triglycerides 1.7 mmol/L | 1.7 × 88.57 | 151 mg/dL |
| Urea 5.0 mmol/L | 5.0 × 2.801 | BUN 14.0 mg/dL |
| Creatinine 88 µmol/L | 88 ÷ 88.40 | 1.00 mg/dL |
Reading a converted result
A conversion changes the unit, not the meaning, and it is only as precise as the number you started with. Labs round their printed results, so converting 5.6 mmol/L of glucose gives 101 mg/dL even though the analyzer may have measured anything from about 100 to 102 mg/dL. Laboratories also round factors differently: some use 18 for glucose, 0.25 for calcium or 60 for uric acid. A one-point difference between your conversion and a printed value is almost always rounding, not an error.
Reference ranges deserve more care than the numbers. A range set in one country is not always the converted version of a range set in another, and some cut-offs are defined differently rather than just expressed in other units. The fasting glucose threshold for diabetes, 126 mg/dL, does convert cleanly to 7.0 mmol/L, but for markers such as creatinine, uric acid and calcium, intervals vary by laboratory, method, age and sex. Compare a converted value against the range printed on your own report, or against a guideline written in the unit you are using. What a glucose of 100 mg/dL or a triglyceride level of 180 mg/dL suggests is covered in fasting glucose at 100 mg/dL and triglycerides at 180 mg/dL, and the borderline LDL band in LDL at 130 mg/dL.
Finally, check that the unit is what you think it is. A converted value far outside anything seen in blood, such as a glucose of 1,800 mg/dL, nearly always means the number was entered in the other unit. The converter above flags that case rather than presenting it as a result.
Converters for individual markers
Some markers have their own converter with ranges and extra context: cholesterol and ApoB, uric acid, bilirubin, vitamin D (ng/mL and nmol/L), testosterone (ng/dL and nmol/L), Lp(a), which has no exact conversion, and the A1C calculator to turn an HbA1c percentage into estimated average glucose. For the usual ranges of a full panel side by side, see the blood test normal range chart.
Already have your bloodwork? Merios reads it next to your watch data.