Merios
Bilirubin — mg/dL and µmol/L

Conversion factor 17.1: divide µmol/L by 17.1 to get mg/dL, multiply mg/dL by 17.1 to get µmol/L. 20.5 µmol/L is 1.2 mg/dL, the same result on two reports. Works for total and direct bilirubin.

Free interactive tool

Bilirubin Converter

Your result is in

Enter your total bilirubin in the unit your lab used. US labs report mg/dL; labs in the UK, Europe, Australia and much of Asia report µmol/L, so the same level reads 1.2 on one report and 20.5 on another.

Educational tool, not a diagnosis. The bands apply to total bilirubin in adults. Direct (conjugated) and indirect bilirubin convert with the same factor, but they have their own reference ranges. This tool does not interpret newborn bilirubin, which is read on charts by age in hours. Reference ranges vary by lab; read your result against the range printed on your own report and discuss it with your clinician.

The conversion, in one line

To go from mg/dL to µmol/L, multiply by 17.1. To go from µmol/L to mg/dL, divide by 17.1. The factor is not an estimate. Micromoles count molecules and milligrams weigh them, and one mole of bilirubin weighs 584.66 grams, so 1 mg/dL (10 mg per liter) works out to 17.104 µmol/L.

In practice everyone uses 17.1, and some quick references round to 17. The gap is well under one percent, smaller than the day-to-day variation in bilirubin itself, so it never changes how a result is read. The same factor applies to total, direct and indirect bilirubin.

mg/dL to µmol/L: the reference table

The values people most often arrive with. The right-hand column uses the same adult reference points as the converter above: the MedlinePlus range for total bilirubin (0.1 to 1.2 mg/dL), the upper limit for direct bilirubin (0.3 mg/dL), and the level around which jaundice can appear.

Total bilirubin in mg/dL converted to µmol/L, 0.1 to 20 mg/dL
Bilirubin in mg/dLSame level in µmol/LWhere that sits (adults)
0.1 mg/dL1.7 µmol/LLower end of the usual adult range
0.3 mg/dL5.1 µmol/LUsual range (upper limit for direct)
0.5 mg/dL8.6 µmol/LWithin the usual adult range
0.8 mg/dL13.7 µmol/LWithin the usual adult range
1.0 mg/dL17.1 µmol/LWithin the usual adult range
1.2 mg/dL20.5 µmol/LUpper limit of the usual adult range
1.5 mg/dL25.7 µmol/LMildly above the range
2 mg/dL34.2 µmol/LMildly above, jaundice can appear
3 mg/dL51.3 µmol/LWell above the range
5 mg/dL85.5 µmol/LWell above the range
10 mg/dL171.0 µmol/LWell above the range
15 mg/dL256.6 µmol/LWell above the range
20 mg/dL342.1 µmol/LWell above the range

µmol/L to mg/dL: the same table in reverse

If your lab is in the UK, Europe, Australia or much of Asia, your report is in µmol/L, while most articles written in the US quote mg/dL. This is the direction you need to read one against the other.

Total bilirubin in µmol/L converted to mg/dL, 2 to 342 µmol/L
Bilirubin in µmol/LSame level in mg/dLWhere that sits (adults)
2 µmol/L0.12 mg/dLLower end of the usual adult range
5 µmol/L0.29 mg/dLUsual range (upper limit for direct)
10 µmol/L0.58 mg/dLWithin the usual adult range
17 µmol/L0.99 mg/dLWithin the usual adult range
20.5 µmol/L1.20 mg/dLUpper limit of the usual adult range
25 µmol/L1.46 mg/dLMildly above the range
34 µmol/L1.99 mg/dLMildly above, jaundice can appear
51 µmol/L2.98 mg/dLMildly above, close to 3 mg/dL
85 µmol/L4.97 mg/dLWell above the range
171 µmol/L10.00 mg/dLWell above the range
256 µmol/L14.97 mg/dLWell above the range
342 µmol/L20.00 mg/dLWell above the range

What the thresholds mean

Total bilirubin, 0.1 to 1.2 mg/dL (1.71 to 20.5 µmol/L). This is the normal adult range MedlinePlus lists, and most labs print something close to it. Ranges vary slightly between labs, so the one printed on your own report is the one that applies to your result.

Direct bilirubin, under 0.3 mg/dL (5.1 µmol/L). Direct, or conjugated, bilirubin is the form the liver has already processed for excretion into bile. A raised direct fraction is more often associated with a liver or bile-flow problem, which is why it is read next to ALT, AST, ALP and GGT.

Mildly above the range, 1.2 to 3 mg/dL (20.5 to 51 µmol/L). A mild rise that is mostly indirect is often seen with Gilbert syndrome, an inherited trait that MedlinePlus Genetics estimates affects 3 to 7 percent of Americans. It is generally a mild condition, and levels tend to go up with fasting, dehydration, illness or intense exercise. Other causes are possible, so a result in this band is worth reviewing with a clinician.

About 2 mg/dL (34 µmol/L) and above. MedlinePlus notes that a level of about 2.0 mg/dL can cause jaundice, a yellow tint to the skin and the whites of the eyes. At 3 mg/dL (51 µmol/L) and above, a result is well beyond the usual range and can be associated with liver, bile duct or red blood cell conditions. Review it with your clinician promptly.

Newborns are different.Newborn jaundice is common, and it is not read against the adult range. The American Academy of Pediatrics 2022 guideline sets thresholds by the baby's age in hours, gestational age and risk factors, using hour-specific charts. This converter changes the unit of a newborn result but does not interpret it; that is the job of the baby's care team.

Where bilirubin sits on a full panel, next to the other liver markers, is shown in the blood test normal range chart.

Two mix-ups to avoid

Total versus direct and indirect. Many reports print total and direct bilirubin, and some add indirect. Indirect bilirubin is usually calculated rather than measured: total minus direct. A total of 1.5 mg/dL with a direct of 0.2 mg/dL means an indirect of 1.3 mg/dL. Compare each line with its own range, not with the total range.

mg/dL versus mg/L. A deciliter is a tenth of a liter, so 1.2 mg/dL is 12 mg/L. If a number looks ten times too high, check which unit the report uses before converting. If you are converting other markers from the same panel, the uric acid converter covers mg/dL and µmol/L for urate, and the table at the bottom of the Lp(a) converter lists factors for glucose, triglycerides, creatinine and more.

Frequently asked questions

What is the bilirubin conversion factor?
17.1. One mg/dL of bilirubin equals 17.1 µmol/L (17.104 exactly, from its molar mass of 584.66 g/mol). Multiply mg/dL by 17.1 to get µmol/L, divide µmol/L by 17.1 to get mg/dL. The factor is the same for total, direct and indirect bilirubin.
How do you convert bilirubin from mg/dL to µmol/L?
Multiply by 17.1. A total bilirubin of 1.2 mg/dL is 20.5 µmol/L, and 2 mg/dL is 34.2 µmol/L. The factor comes from the molar mass of bilirubin, 584.66 g/mol, which gives 17.104 µmol/L per mg/dL. Most labs and references round it to 17.1.
How do you convert bilirubin from µmol/L to mg/dL?
Divide by 17.1, or multiply by 0.0585. A level of 17 µmol/L is 0.99 mg/dL, 34 µmol/L is 1.99 mg/dL and 51 µmol/L is 2.98 mg/dL. Dividing by 17 in your head gets you within about one percent.
Is 20 µmol/L bilirubin normal?
For total bilirubin in an adult, usually yes. 20 µmol/L is 1.17 mg/dL, and MedlinePlus lists a normal total bilirubin of 0.1 to 1.2 mg/dL, or 1.71 to 20.5 µmol/L. The range on your own report is the one that applies.
What bilirubin level causes jaundice?
MedlinePlus notes that a blood bilirubin level of about 2.0 mg/dL (34 µmol/L) can cause jaundice, the yellowing of the skin and the whites of the eyes. It becomes more obvious as the level rises. Jaundice is a sign, not a diagnosis, and a new yellow tint is worth raising with a clinician promptly.
Is the conversion factor different for direct and total bilirubin?
No. Direct (conjugated), indirect (unconjugated) and total bilirubin all convert with the same factor, 17.1, because the molecule being counted is the same. What differs is the reference range: MedlinePlus lists direct bilirubin as less than 0.3 mg/dL, or less than 5.1 µmol/L.
Can I use this converter for a newborn's bilirubin?
The unit math is the same, so it will convert a newborn result correctly. It does not interpret it. Newborn jaundice is read on charts that depend on the baby's age in hours, gestational age and risk factors, as set out in the American Academy of Pediatrics 2022 guideline. Your baby's care team reads those levels.
Does Merios store these numbers?
No. The converter runs entirely in your browser. Your inputs never leave your device and are not sent to a server.

Track this in Merios

One bilirubin curve, whatever unit each lab used.

Merios reads the units off each report you upload and keeps every marker on one scale, so a result in µmol/L from one lab and one in mg/dL from another sit on the same line instead of looking like two different people.

References: MedlinePlus, Bilirubin blood test, U.S. National Library of Medicine. · MedlinePlus Genetics, Gilbert syndrome, U.S. National Library of Medicine. · Kemper AR, Newman TB, Slaughter JL, et al. Clinical Practice Guideline Revision: Management of Hyperbilirubinemia in the Newborn Infant 35 or More Weeks of Gestation. Pediatrics 2022;150(3):e2022058859. · Educational tool, not a diagnosis; interpret any result with the reference range printed on your own report and with your physician.